On 29 December 2009 with the Directive 2006/42/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 17 May 2006 on Machinery, and amending Directive 95/16/EC, new provisions with regard to the placing on the market of machinery came into force. The transition from the old to the new legal situation was not fluent, i.e. as from 29 December 2009 exclusively the new regulations are to be applied.
As a result of this amendment to the legal guidelines we would like to give you the following brief explanation relating to the CE marking of our products and the inclusion of installation/fitting instructions or assembly instructions
All the products placed on the market by the companies named within the scope are subject to either the EMC Directive (2014/30/EU) and/or the Low-voltage Directive (2014/35/EU) and/or Radio Equipment Directive 2014/53/EU for this reason are to be identified with the CE marking, even if these products constitute partly completed machinery as defined in § 16 section 3 of the Machinery new Directive on Machinery and § 6 section 3 of the Machinery Ordinance -9th GPSGV (Equipment and Product Safety Act). This follows from Article 1 (2)(k) of the Directive on Machinery 2006/42/EC.
Since the products placed on the market by the companies named within the scope of this Directive (see below) involve partly completed machinery as defined by the new Directive on Machinery Directive and will be delivered solely to customers who will make complete machines out of these products (B2B), assembly instructions will be produced that will only be made available for the first and one time when the product is sampled or changed. Furthermore, there is the possibility of downloading the assembly instructions directly from the Internet by going to "www.dewert.de" or "www.okin.de".
Due to the legally binding requirements of the Machinery Directive 2006/42 / EC, there is no room for maneuver to issue further documents.
All products put on the market by DewertOkin GmbH under the name DEWERT or OKIN.
Kirchlengern, 1st September 2021
CE + Directive on machinery (EN)